Today I removed all the screws holding the molds to the strong back and my son and I lifted the boat off and set it down on some moving blankets. The picture above is after the mold halves have been removed and as you can see, it was necessary to use a hammer to get everything out of the interior. (Leave the floorboard supports of course).
I had to remove the top of the strong back and made some supports for the bottom of the boat by utilizing the forms obtained from the full sized Glen-L plans. I found the corresponding mold station forms and traced them onto new 3/4" plywood then cut them out to leave a cavity that the boat would rest on perfectly. I added a moving blanket to make sure that nothing gets scratched.
Now I'm ready to start on the interior.
No comments:
Post a Comment